Traditions Buckhunter Pro Pistol Bedienungsanleitung PDF herunterladen (Seite 2)

Do not cap the pistol until you are ready to ﬁre and the thumb safety is engaged.

FUNCTION AND OPERATION:

Before loading your new Traditions pistol take some time to familiarize yourself with the

operation of the hammer, trigger and the hammer block safety system.

1. Insure the pistol is unloaded and unprimed (uncapped) and the hammer at rest against the frame.

2. Slowly pull back the hammer until the ﬁrst audible click is heard. This is the “Half-Cock” position.

Note: The “Half-Cock” position is not a safety and should not be used as one.

3. Pull the hammer all the way to the rear until a second click is heard. This is the “Full-Cock” position.

Note: When the hammer is in the “Full-Cock” position the pistol is ready to ﬁre.

4. To engage the thumb safety, position the hammer in the full-cock position against the frame. Holding

the pistol in your right hand use your right thumb, rotate the safety (located on the left side of the

frame) all the way back, insuring that the red dot on the frame is covered by the safety lever.

5. To ﬁre the pistol it will be necessary to release (far forward) the safety before the hammer can be pulled.

The hammer block safety prevents movement of the hammer only. If the trigger is intentionally

or inadvertently pulled to the rear when the hammer safety is disengaged the pistol will ﬁre.

The hammer block safety is (as all mechanical devices are) subject to failure if mistreated,

neglected or altered. Before each and every use of the pistol, check the function of this

safety before loading the pistol. If the safety is not working correctly do not use the pistol.

Seek professional gunsmithing help or return it to Traditions for service.

RECOMMENDED LOADS:

Refer to the Loading and Shooting Instructions as found in the Traditions Shooting and Warranty Booklet.

The following are the recommended loads for the Buckhunter Pro™ In-Line Pistol.

Round Patch Most Accurate Maximum

Caliber Ball Thickness Grains Grains

.50 .490 .015 25-50 80

.54 .530 .015 25-50 80

Most Accurate Maximum

Caliber Sabot/Conical Grains Grains

.50 .50 25-50 80

.54 .54 25-50 80

NOTE: ALL CHARGES LISTED ARE FFG (2F) OR PYRODEX

Pyrodex

P can be substituted

CAUTION!

1375 Boston Post Road

P.O. Box 776

Old Saybrook, CT 06475

Tel. 860-388-4656

Call or write for free catalog showing the industry’s

widest selection of muzzleloading guns and accessories

Rev

0298

1 2

Keine Kommentare

Traditions Buckhunter Pro Pistol Bedienungsanleitung Seite 2